rough sketches
Featured
Sand Shaper
By sequentially opening and closing different holes in the top two layers, different forms develop as sand is added and subtracted.
Offsetting the two spirals by 180 degrees causes them to overlap and form a cone.
Material: laser-cut plywood
Twisting the spiral slightly causes the layers to overlap and form a cone.
Material: laser-cut plywood
Offsetting the two spirals slightly causes them to overlap and form a cone.
Material: laser-cut plywood
Stop-motion animation of laser-cut, laminated plywood rings, showing the same structure in two different orientations.
As the gears rotate inside each other, they incrementally progress.
Material: laser-cut acrylic
Sliding these pentagonal concentric rings back and forth creates an illusion of depth.
Material: laser-cut mat board
By sequentially opening and closing different holes in the top two layers, different forms develop as sand is added and subtracted.